Russound SIX-SOURCE CONTROLLER CAM6.6 - Manual (Page 49)

49
The following items make up the Installation Menu:
PERIPH SETUP (PerSu) SOURCE SETUP (SrcSu) ZONE SETUP (ZonSu)
CTRLR SETUP (CtlSu) POWER MGT (PwMgt) LEARN IR (LrnIR)
MACRO EDITOR (MacEd) SYSTEM INFO (SInfo)
PERIPH SETUP (PerSu)
Note: For CAM6.6, Peripheral Setup is not applicable. “N No ot t A Av va ai il l” shows on the keypad.
Peripheral Setup allows the CAM6.6’s optional internal source to be configured.
The following items can be found in the PERIPH SETUP menu:
MEM NAME (MemNm) BANK NAME (BnkNm) CONTROLLR ID (CtlId) REGION (Rgion)
FACTORY INIT (FInit) SYSTEM INFO (SInfo)
MEM NAME (MemNm)
NOTE: A memory preset must be created and saved before it can be named. Once it is saved, the
preset’s Tuner #, Bank # and Memory # must be entered in the following procedure.
This procedure accesses a name entry field to enter a custom name for a memory preset. See
Periph Setup - Flow Chart on page 64
1. BANK # – Select the BANK # of the memory preset.
(Bank#)
2. MEMORY # – Select the MEMORY # of the preset to be named.
(Mem #)
3. MEMORY NAME – Use the volume up/down keys to select a character and left/right
(MemNm) keys to change a character position. A blinking cursor indicates
placement of the character being entered. Names can be from 1
to 5 characters in length. If adding names from 6-12 characters,
it is suggested you use an optional UNO-S2 keypad.
BANK NAME (BnkNm)
This procedure accesses a name entry field to enter a custom name for each of the tuner’s six
banks.
See Periph Setup - Flow Chart on page 64
1. BANK # – Select the BANK # of the memory preset.
(Bank#) (continued)
INSTALLER
INSTALLATION MENU