Raritan Engineering Crown Head II - Manual (Page 6)

INSTALLATION
Parts Included
All Toilets
Toilet Bowl (Household or Marine)
Seat and Cover
Discharge pump assembly
Heavy Duty Push Button Switch (#164000)
Mounting pads
Lower Motor Cover
Sea Water Model
Remote Intake Pump
3/4" Hose Barb straight fitting
3/4" Hose Barb - 90° elbow fitting
Plug Fitting
In-Line Strainer with fittings
3/4" Stainless Steel Hose Clamps (2)
Pressurized Freshwater Models
Atmospheric Vacuum Breaker with fittings
Solenoid Valve with fittings
Solenoid Valve Mounting Bracket
Flush Control Options
Toilet Control (#TC*+) wall switch
Raritime Control (#RTC*) times the push button
Flush Control (#SWF100+) independant control
Additional Parts Required
•
Four 1/4" (6mm) stainless steel mounting
bolts or lag screws and washers (Sea Water
Models)
• Two 1/4" (6mm) stainless steel mounting bolts
or lag screws and washers (Freshwater Models)
• Four 5/16" (8mm) stainless steel mounting
bolts or lag screws and washers
• 1 1/2" (38mm) I.D. discharge hose
• 3/4" (19mm) I.D. reinforced intake hose
• 3/4" (19mm) and 1 1/2" (38mm) hose clamps
(two for each connection below waterline)
• Wire
• Terminals
INSTALLATION
• Fuse/circuit breaker
Tools Required
•
5/16" nut driver
• Wrench or screw driver (depending on mounting
fastener)
• Bit for drilling mounting surface (depending on
fastener used)
• Wire cutters
• Wire terminal crimpers
• Hose cutters
• Tape measure
6
* Specify Voltage
+ Specify Color