Radio Shack ET-910 - Manual (Page 11)

11
6. Press the AC cord into the top
and bottom grooves on the left
side of the bracket, press the
modular cord into the top and
bottom grooves on the right side
of the bracket, then plug the
modular cord into a modular
phone jack.
7. Line up the keyhole slots on the
bracket with the screws on the
wall, then slide the base down
onto the screws until it is secure.
8. Press up on the handset holder
to remove it, turn it over so its
tabbed edge faces up, then
press it back down into its slot
on the base.
9. Plug the ET-910’s AC cord into a
standard AC outlet.
10. For the best reception, adjust
the base’s antenna so it stands
straight up.
Note: If you want to remove the sup-
plied bracket after attaching it, simply
press in the tab on each side of the
bracket and lift the bracket away from
the base.
HANDSET IN USE
1
4
7
2
5
8
0
3
6
9
#
GHI
PRS
TONE
ABC
JKL
TUV
OPER
DEF
MNO
WXY
CHARGE
CORDLESS TELEPHONE ET-910
T ONE
PULSE
OFF
ON RINGER
43-1085.fm Page 11 Tuesday, August 17, 1999 2:31 PM