Radio Shack ET-910 - Manual (Page 14)

14
SETTING THE
PULSE/TONE SWITCH
Set PULSE/TONE for the type of ser-
vice you have. If you are not sure
which type you have, do this test.
1. Set PULSE/TONE to TONE .
2. Press TALK on the handset or
SPKR (speakerphone) on the
base and listen for a dial tone.
3. Press any number other than 0.
If the dial tone stops, you have
touch tone service. Leave
PULSE/TONE set to TONE .
If the tone continues, you have
pulse service. Set
PULSE/TONE
to PULSE .
4. To hang up, either place the
handset on the cradle or press
OFF on the handset or SPKR on
the base.
ADJUSTING THE
RINGERS
The ET-910 lets you control its base
and handset ringers separately. You
can choose from four different ringer
types for the base and handset, or
turn off the ringer on one or both.
Note: If you turn off the ringer on the
base or handset, you can still make
calls normally using that keypad and
you can still answer calls if you hear
another phone on that same line ring
(see “Operation” on Page 16).
Checking/Setting the Ringer
Type
The ET-910’s base and handset are
both preset to use the same ringer
type (ringer type
1 ). Follow these
steps to change the base or the
handset’s ringer type using that key-
pad.
1. Press PROG on the base or
handset. The indicator above
SPKR on the base or TALK on
the handset flashes.
TONE PULSE OFF ON RINGER
0 # TONE OPER
HOLD FLASH PRIVACY
MEM REDIAL PROG
INT.CM SPKR
VOLUME
DIGITAL
TALK INT.CM OFF
PRIVACY / LOW BATT
1
4
7
2
5
8
0
3
6
9
#
GHI
PRS
TONE
ABC
JKL
TUV
OPER
DEF
MNO
WXY
HOLD FLASH PRIVACY
MEM REDIAL PROG
0 # TONE OPER
HOLD FLASH PRIVACY
MEM REDIAL PROG
INT.CM SPKR
VOLUME
DIGITAL
TALK INT.CM OFF
PRIVACY / LOW BATT
1
4
7
2
5
8
0
3
6
9
#
GHI
PRS
TONE
ABC
JKL
TUV
OPER
DEF
MNO
WXY
HOLD FLASH PRIVACY
MEM REDIAL PROG
43-1085.fm Page 14 Tuesday, August 17, 1999 2:31 PM