Radio Shack ET-910 - Manual (Page 20)

20
USING FLASH
You can use FLASH to produce a
switchhook signal for special phone
services, such as call waiting. If you
have call waiting, press
FLASH to
take an incoming call without discon-
necting the current call. Press
FLASH
again to return to the first call.
Note: If you do not have any special
phone services, pressing
FLASH
might disconnect the current call.
USING TONE SERVICES
ON A PULSE LINE
If you have pulse service, you can
temporarily switch to sending tones
for banking services or computer
transactions.
Dial the number as usual, then sim-
ply press
TONE at the appropriate
place in the call to change to tone di-
aling. The phone automatically re-
turns to pulse dialing when you end
the call.
CHANGING CHANNELS
The ET-910 continuously scans 10
channels (frequency pairs used be-
tween the base and the handset) and
automatically selects the one with
the least interference each time you
make or receive a call using the
handset.
If you notice interference during a
call, however, you can repeatedly
press
INT.CM on the handset to try
and find a clearer channel. The ET-
910 changes to a different channel
each time you press the key.
Note: You cannot change the chan-
nel while using
HOLD .
0 # TONE OPER
HOLD FLASH PRIVACY
MEM REDIAL PROG
INT.CM SPKR
VOLUME
DIGITAL
TALK INT.CM OFF
PRIVACY / LOW BATT
1
4
7
2
5
8
0
3
6
9
#
GHI
PRS
TONE
ABC
JKL
TUV
OPER
DEF
MNO
WXY
HOLD FLASH PRIVACY
MEM REDIAL PROG
TALK INT.CM OFF
PRIVACY / LOW BATT
1
4
7
2
5
8
0
3
6
9
#
GHI
PRS
TONE
ABC
JKL
TUV
OPER
DEF
MNO
WXY
HOLD FLASH PRIVACY
MEM REDIAL PROG
43-1085.fm Page 20 Tuesday, August 17, 1999 2:31 PM