Onkyo CNP-1000 - Manual (Page 34)

En-
2
Setting the Satellite Radio Mode
Before you can listen to XM Satellite Radio, you must
set the SAT Radio Mode to “XM”.
Selecting XM Satellite Radio
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ] but-
tons to select “7. Hardware
Setup”, and then press [ENTER].
The Hardware Setup menu appears.
3 Use the Up and Down [ ]/[ ] but-
tons to select “3. Tuner”, and
then press [ENTER].
The Tuner screen appears.
RECEIVER
SETUP
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog
Multich
5. HDMI
7–3. Tuner
SAT Radio Mode
Antenna Aiming
SURIUS Parental Lock XM
4 Use the Left and Right [ ]/[ ]
buttons to select “XM”.
If there are 2 items on the Tuner
screen, use Up and Down [ ]/[ ]
buttons to select “SAT Radio
Mode”.
Pressing the Left and Right [
]/[ ]
buttons cycles through the following
options: None
→
XM
→
SIRIUS
→
XM/SIRIUS
None: Select if you’re not using
Satellite Radio.
XM: Select to use XM Satellite
Radio.
SIRIUS: Select to use SIRIUS Satel-
lite Radio.
XM/SIRIUS: Select to use XM Satel-
lite Radio and SIRIUS Sat-
ellite Radio.
5 When you’ve finished, press the
[SETUP] button.
Setup closes.
AV receiver On the AV receiver, press the
[TUNER] button repeatedly to
select “XM”.
Remote
controller
On the remote controller, press
the [TUNER] button repeatedly to
select “XM”.
If “CHECK XM TUNER” appears on
the display, make sure the XM Mini-
Tuner is connected properly.
TUNER TUNING /