Onkyo CNP-1000 - Manual (Page 37)

En-
5
Selecting the Previous Channel:
Presetting XM Channels
You can store a combination of up to 40 of your favorite
XM channels and AM/FM radio stations as presets.
■ Selecting Presets
■ Deleting Presets
Displaying XM Radio Information
The following information can be displayed:
Note:
If the category, artist, or song title is not available, “- - -”
will be displayed instead.
AV receiver
Remote
controller
To listen to the previously
selected XM channel, press the
[RETURN] button.
1 Tune into the XM channel that
you want to store as a preset.
2
AV receiver
Press the [MEMORY] button.
The preset number flashes.
3
AV receiver
While the preset number is flash-
ing (about 8 seconds), use the
PRESET [
]/[ ] buttons to
select a preset from 1 through 40.
4
AV receiver
Press the [MEMORY] button
again to store the channel.
The channel is stored and the preset
number stops flashing.
Repeat this procedure for all of your
favorite XM channels.
AV receiver
Remote
controller
To select a preset, use the PRE-
SET [
]/[ ] buttons, or the
remote controller’s CH [+/–] but-
ton.
1 Select the preset that you want to
delete.
See the previous section.
2
AV receiver
While holding down the [MEM-
ORY] button, press the [TUNING
MODE] button.
The preset is deleted and its number
disappears from the display.
AV receiver
Remote
controller
Press the [DISPLAY] button
repeatedly to cycle through the
available information.
Channel name
Category
Artist
Song title
Listening mode