Onkyo CNP-1000 - Manual (Page 9)

En-
9
Positioning the SiriusConnect Home
antenna
You can check the strength of the SIRIUS Satellite Radio
signal and adjust the position of the SiriusConnect Home
antenna accordingly.
Notes:
• So long as the signal strength is good, you can enjoy
SIRIUS Satellite Radio by using either satellite or ter-
restrial reception.
• Terrestrial signals are only available in certain areas.
• The SIRIUS information on the Satellite Radio screen
is only displayed when the SAT Radio Mode is set to
“SIRIUS” or “XM/SIRIUS” (see page 2).
• If you’re using both XM Satellite Radio and SIRIUS
Satellite Radio and the Satellite mode is set to
“XM/SIRIUS” (see page 2), signal strength meters for
both systems appear on the same screen.
1 Press the [RECEIVER] button,
followed by the [TUNER] button,
and [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ] but-
tons to select “7. Hardware
Setup”, and then press [ENTER].
The Hardware Setup menu appears.
Note:
If the SAT Radio Mode is set to “None”
(see page 2), the “Antenna Aiming”
item is not available.
RECEIVER
SETUP
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog
Multich
5. HDMI
3 Use the Up and Down [ ]/[ ] but-
tons to select “3. Tuner”, and
then press [ENTER].
The Tuner screen appears.
4 Use the Up and Down [ ]/[ ] but-
tons to select “Antenna Aiming”,
and then press [ENTER].
The Satellite Radio screen appears.
The name of the currently selected
input selector is displayed in a box.
5 Position the SiriusConnect Home
antenna so that as many bars as
possible (up to 3) appear on the
SIRIUS Satellite signal strength
meter.
If you cannot receive a satellite signal,
position the SiriusConnect Home
antenna so that as many bars as possible
(up to 3) appear on the SIRIUS Terres-
trial signal strength meter.
7–3. Tuner
SAT Radio Mode
Antenna Aiming
SURIUS Parental Lock SIRIUS
Satellite Terrestrial
SIRIUS ID
SIRIUS Antenna Aiming
- - - - - - - - - - - -
7–3. Tuner