Onkyo HT-R520 - Manual (Page 46)

46
Advanced Setup
To get the best from surround sound, it’s important that
the sound from each speaker reaches the listener at the
same time. To achieve this, you need to specify the dis-
tance from each speaker to the listening position.
Notes:
• The Center and Subwoofer distances can be set up to
5 ft. (1.5 m) more or less than the Front distance. For
example, if the Front distance is set to 20 ft. (6 m), the
Center and Subwoofer distances can be set between 15
and 25 ft. (4.5 and 7.5 m).
• The SurrRight, Surr Left, and Surr Back distances can
be set up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less
than the Front distance. For example, if the Front dis-
tance is set to 20 ft. (6 m), the SurrRight, Surr Left,
and Surr Back distances can be set between 5 and 25
ft. (1.5 and 7.5 m).
Advanced setup cannot be set while headphones are connected,
Speaker B is on, or the multi channel input is being used.
Speaker Distance
1 Measure and make a note of the
distance from each speaker to
the listening position.
2 Press the [AMP] button followed
by the [SETUP] button on the
remote controller.
3 Use the Up and Down [ ]/[ ]
buttons to select “2. SP Dis-
tance,” and then press the
[ENTER] button.
CD
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
V1 V2 V3
DVD MULTI CH
--/---
TAPE TUNER
INPUT I
+
-
ENTER
SET UP
GUI DE RE TURN
EXIT
CINE FLTR
LEVEL - LEVEL + CH SEL TEST TONE
DSP DIRECT
STEREO ALL ST SURR
L NIGHT
TO P M ENU MEN U
VOL
+
-
CDR
SAT
AMP + _
TV VCR CABLE
DVD CD MD
DISC CH
TONE
TUNER/
TAPE
DISPLAY
TV
INPUT
PREV
CH
DIMMER SLEEP
RANDOM SP A SP B
MUTING
ANGLE
SEARCH
SUBTITLE AUDIO
MEMORY A-B REPEAT
ON STANDBY T V
TV CH
T V VOL
RC-570M
REC
LAST M
REMOTE MODE
OPEN/CLOSE
DSP
VIDEO OFF
OR-EQ
LEVEL - LEVEL +
SETUP
AMP
ENTER
DISPLAY
AMP
ENTER
ENTER
4 Use the [DISPLAY] button to
switch
ft or m .
ft: distances in feet. Can be set from
1 to 30 feet in 1-foot steps.
m: distances in meters. Can be set
from 0.3 to 9 meters in 0.3-meter
steps.
5 Use the Left and Right [ ]/[ ]
buttons to specify the distance
for “Front,” then press the Down
[
] button to select the next
speaker.
6 Repeat step 5 for all speakers.
Note:
Speakers that you set to No or None in
the Speaker Configuration (page 48)
cannot be selected.
7 Press the [SETUP] button.
Setup closes.
DISPLAY
ENTER