Onkyo HT-R520 - Manual (Page 47)

47
Advanced Setup —Continued
With this function you can adjust the volume of each
speaker so that all speakers can be heard equally at the
listening position.
Notes:
• This procedure can also be performed by using the
remote controller. First press the [TEST TONE] but-
ton to output the test tone. Use the [LEVEL–] and
[LEVEL+] buttons to adjust the levels, and use the
[CH SEL] button to select the speakers.
Speaker Levels
1 Press the [AMP] button followed
by the [SETUP] button on the
remote controller.
2 Use the Up and Down [ ]/[ ]
buttons to select “3. Level Cal,”
and then press the [ENTER] but-
ton.
A pink noise test tone is output by the
front left speaker.
Speaker levels cannot be set while the
HT-R520 is muted.
CD
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
V1 V2 V3
DVD MULTI CH
--/---
TAPE TUNER
INPUT I
+
-
ENTER
SET UP
GUI DE RE TURN
EXIT
CINE FLTR
LEVEL - LEVEL + CH SEL TEST TONE
DSP DIRECT
STEREO ALL ST SURR
L NIGHT
TO P M ENU MEN U
VOL
+
-
CDR
SAT
AMP + _
TV VCR CABLE
DVD CD MD
DISC CH
TONE
TUNER/
TAPE
DISPLAY
TV
INPUT
PREV
CH
DIMMER SLEEP
RANDOM SP A SP B
MUTING
ANGLE
SEARCH
SUBTITLE AUDIO
MEMORY A-B REPEAT
ON STANDBY T V
TV CH
T V VOL
RC-570M
REC
LAST M
REMOTE MODE
OPEN/CLOSE
DSP
VIDEO OFF
OR-EQ
LEVEL - LEVEL +
SETUP
ENTER
AMP
ENTER
ENTER
3 Turn up the volume so that you
can hear the test tone suffi-
ciently.
While each speaker outputs the test
tone, its name appears on the display, as
shown.
4 Use the Left and Right [ ]/[ ]
buttons to adjust the speaker
level, and use the Down [
] but-
ton to select the next speaker.
The level can be adjusted from –12 to
+12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
5 Repeat step 4 so that the level of
the test tone from each speaker
is the same.
Speakers that you set to No or None in
the Speaker Configuration (page 48) do
not output the test tone.
6 Press the [SETUP] button.
Setup closes.
Don’t forget to turn down the volume if
you turned it up while setting the levels.
ENTER
ENTER