Onkyo TX-SR803/803E - Manual (Page 40)

40
First Time Setup
This section explains the settings that you need to make
before using the AV receiver for the very first time.
With the supplied speaker setup microphone, the Auto-
matic Speaker Setup function can measure the test tone
output by each speaker and automatically determine the
number of speakers connected, the crossover frequency,
the distance from each speaker to the listening position,
and so on. Before using this function, connect and posi-
tion all of your speakers.
Automatic Speaker Setup
1 Turn on the AV receiver and the
connected TV.
On the TV, select the input to which the
AV receiver is connected.
THX
10 - - / - - - 11 12
REMOTE MODE
HDD RECEIVER
TAPE/AMP
DVD CD
ZONE2
SAT TV VCR CABLE
MD CDR
STEREO SURR
DIRECT
SUBTITLE AUDIO
ALLST
PLAY MODE
VIDEO OFF
REPEAT
RANDOM REC PLAYLIST
OPEN/CLOSE
Re-EQ
+
-
T V CH
T V VOL
ENTER
SET UP
TO P M ENU MEN U
VOL
+
-
CH
DISPLAY
PREV
CH
DIMMER SLEEP
MUTING
LISTENING MODE
INPUT SELECTOR
3 2
MACRO
1
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
INPUT I
ON STANDBY
T V
CD
V1 V2 V3
MULTI CH DVD
TUNER
PHONO
DISC
ALBUM
V4
TAPE
PURE A
TEST TONE CH SEL LEVEL LEVEL
L NIGHT
RE TURN
3, 4
OFF TONE ZONE 2
ZONE 2 LEVEL
PHONES STEREO DIMMER MEMORY
LISTENING MODE
TUNING MODE SETUP
PRESET PRESET TUNING
RETURN ENTER SETUP MIC
VIDEO S VIDEO DIGITAL
VIDEO 4 INPUT
AUDIO L R CLEAR
STANDBY/ON
STANDBY
MASTER VOLUME
PHONO
ZONE 2
DISPLAY PURE AUDIO TUNER TAPE VIDEO 4 VIDEO 3 VIDEO 2 VIDEO 1 DVD MULTI CH CD
OFF ON
POWER
SETUP MIC
1
2, 5
Note: If any of your speakers is 4 ohms, change the
minimum speaker impedance setting before running
the automatic speaker setup (see page 46).
2 Put the speaker setup micro-
phone in the listening position.
Notes:
• Make sure the microphone is hori-
zontal.
• If there’s an obstacle between the
microphone and any speaker, the
automatic setup will not work cor-
rectly. Set up the room as you would
when enjoying a DVD.
• Positioning the microphone close to
where your ears would normally will
provide better results. You can adjust
the height of the microphone by
using a tripod or level table.
Connect the setup microphone to
the SETUP MIC jack.
Notes:
• If the AV receiver was previously
muted, it will be unmuted.
• Automatic speaker setup cannot be
performed while a pair of head-
phones is connected.
SETUP MIC
Microphone
Auto Speaker Setup
========================
Push Enter:Start
Caution! Loud sound.