Onkyo TX-SR803/803E - Manual (Page 46)

46
First Time Setup —Continued
If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or next generation HDD-compat-
ible component to the TAPE IN/OUT or VIDEO 3 IN
jacks, for
to work properly, you must change this
setting.
This setting can only be changed on the AV receiver.
iPod photo: If you’re using an iPod photo with the
DS-A1 Remote Interactive Dock, connect the DS-A1 to
the VIDEO 3 IN jacks.
Note:
HDD can be selected for the TAPE input selector or
VIDEO 3 input selector, but not both at the same time.
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Minimum Speaker Impedance to 4
ohms.
Note:
Before you change this setting, turn down the volume.
Notes:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
Changing the Input Display
1 Press the [TAPE] or [VIDEO 3]
input selector button so that
“TAPE” or “VIDEO3” appears on
the display.
2 Press and hold down the [TAPE]
or [VIDEO 3] input selector but-
ton (about 3 seconds) to change
the setting.
Repeat this step to select MD, CDR, or
HDD.
For the TAPE input selector, the setting
changes in this order:
TAPE
→
MD
→
CDR
→
HDD
→
For the VIDEO 3 input selector, the set-
ting changes in this order:
VIDEO 3
→
HDD
→
VIDEO 3
→
PUSH TO OPEN
STANDBY/ON
STANDBY
MASTER VOLUME
PHONO
ZONE 2
DISPLAY PURE AUDIO TUNER TAPE VIDEO 4 VIDEO 3 VIDEO 2 VIDEO 1 DVD MULTI CH CD
OFF ON
POWER
1, 2 1, 2
VIDEO 3
or
TAPE
or
TAPE
VIDEO 3
Minimum Speaker Impedance
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “3. Speaker
Setup,” and then press [ENTER].
The Speaker Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “Speaker
Impedance,” and then press
[ENTER].
4 Use the Left and Right [ ]/[ ]
buttons to select:
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5 Press the [SETUP] button.
Setup closes.
If you change this setting, you must run the automatic
speaker setup again (see page 40).
RECEIVER
ENTER
ENTER
3.Speaker Setup
------------------------
0.Speaker Impedance
2.Speaker Configuration
3.Speaker Distance
4.Level Calibration
5.THX Audio Setup
6.Equalizer Settings
1.Speaker Impedance
ENTER