Onkyo TX-SR803/803E - Manual (Page 57)

57
Using the Multichannel DVD Input
The multichannel DVD input is for connecting a compo-
nent with a 5.1/7.1-channel analog audio output, such as
a DVD player, DVD-Audio/SACD-capable player, or an
MPEG decoder. See page 28 for hookup information.
Note:
• While the multichannel DVD input is selected, the
Speaker Configuration settings on page 70 are
ignored, and signals from the multichannel DVD input
are fed to the subwoofer, front left, front right, center,
surround left, surround right, surround back left, and
surround back right speakers as they are.
Input Channel
If you’ve connected a 7.1-channel audio output to the
multichannel DVD input, select 7.1ch. If you’ve con-
nected a 5.1-channel audio output, select 5.1ch.
Subwoofer Sensitivity
Some DVD players output the LFE channel from their
subwoofer output at 15 dB higher than normal. You can
change the subwoofer sensitivity to match your DVD
player. Note that this setting only affects signals con-
nected to the SUBWOOFER input jack of the multichan-
nel DVD input.
You can select 0 dB, +5 dB, +10 dB, or +15 dB.
If you find that your subwoofer is too loud, try the
+10 dB or +15 dB setting.
Using the Multichannel DVD Input
Press the [RECEIVER] REMOTE
MODE button, followed by the
[MULTI CH] button.
The MULTI CH indicator appears on
the display.
Audio from the multichannel DVD
input will now be used for the DVD
input source.
THX
10 - - / - - - 11 12
REMOTE MODE
HDD RECEIVER
TAPE/AMP
DVD CD
ZONE2
SAT TV VCR CABLE
MD CDR
STEREO SURR
DIRECT
SUBTITLE AUDIO
ALLST
PLAY MODE
VIDEO OFF
REPEAT
RANDOM REC PLAYLIST
OPEN/CLOSE
Re-EQ
+
-
T V CH
T V VOL
ENTER
SET UP
TO P M ENU MEN U
VOL
+
-
CH
DISPLAY
PREV
CH
DIMMER SLEEP
MUTING
LISTENING MODE
INPUT SELECTOR
3 2
MACRO
1
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
INPUT I
ON STANDBY
T V
CD
V1 V2 V3
MULTI CH DVD
TUNER
PHONO
DISC
ALBUM
V4
TAPE
PURE A
TEST TONE CH SEL LEVEL LEVEL
L NIGHT
RE TURN
RECEIVER
MULTI CH
SETUP
ENTER
RECEIVER
5
MULTI CH
MULTI CH indicator
Multichannel DVD Input Settings
1 While the DVD input is selected,
press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “4. Input Setup,”
and then press [ENTER].
Use the Up and Down [ ]/[ ]
buttons to select “3. MULTICH,”
and then press [ENTER].
The Multichannel Analog menu
appears.
3 Use the Up and Down [ ]/[ ]
buttons to select the settings,
and use the Left and Right
[
]/[ ] buttons to change them.
The settings are explained below.
4 Press the [SETUP] button.
Setup closes.
RECEIVER
ENTER
ENTER
3.XM Antenna Aiming
4-3.MULTICH
-----------DVD----------
a.Input Channel:5.1ch
b.Subwoofer Sensitivity
: 0dB
ENTER