Olympus DS-4000 - Manual (Page 44)

44 44
4
Connecting Recorder to PC
Place the recorder in the cradle
1 Insert end A of the USB cable to your PC’s USB
port or USB hub.
2 Connect end b of the USB cable to the cradle.
3 Turn ON the recorder, then set the recorder in the
cradle.
If “REMOTE” is displayed on recorder, it indicates proper
connection.
........................................................................................................
Notes
Connecting to Your PC Using the Cradle
Connecting Recorder to PC
Disconnecting Recorder from PC
• Never touch the contact points at the bottom of the cradle, as that
may cause bad connection.
• With a PC connected, the recorder cannot be operated with the foot
switch (RS25/26). When connecting the recorder to a PC via the cradle,
remove the foot switch.
To avoid data corruption or loss, make sure that the recorder’s
record/play indicator lamp isn’t flashing, before removing the
recorder from the cradle or disconnect the cable from the
recorder terminal.