Sylvania SY4100 - Manual (Page 20)

19
To install the PIR Motion Sensor, please follow these steps :
l Take out the screws or double sided adhesive and install the mounting bracket
on the wall. Press the ball joint portion into the bracket until it snaps securely.
(Secure the mounting bracket on the wall, 2 meters above the floor).
l Place the PIR sensor on the mounting bracket.
l Test the PIR sensor by walking within its range. When the sensor is triggered,
the red LED light will flash once for 1 sec ond.
The magnetic Door/Window detector is a contact sensor, and should be applied on a
door or window. When the magnetic contact is opened (broken) or the battery is low, the
sensor will send out a message to the main console. A message on the triggered sensor
can be seen on the Main Console’s LCD display.
Door/Window Detector (for DC 12V battery)
Door/Window Detector
Button function
1. Magnet.
2. Transmit LED : When the
sensor is activated, the LED
will light for 1 sec.
3. Magnet sensor
4. Battery Cover : Remove the
cover and install one 12V
alkaline battery here.
Note: The magnet and magnet
sensor must be placed in
parallel position (triangle arrow)
to ensure a better setting.