Sylvania SY4100 - Manual (Page 27)

26
“Installation template for wall mounting of main control panel”
1. Use the template on the right to mark positions for mounting
screws to install the main control panel on the wall.
2. Once the mounting screw positions have been marked, drill 3/16”
pilot holes and install the plastic wall anchors supplied.
3. Install the mounting screws into the plastic wall anchors so that
the heed of the screw extends approximately 1/4” from the wall.
4. Remove the rubber/plugs located at the top 2 holes on the bottom
of the main control panel, and line up these holes with the
mounting screw heads. Slide the main control panel over the
mounting screws and gently push down onto the screws so that it
is secure
.
Installation Template