Sylvania SY4100 - Manual (Page 22)

21
When the system is in the process of arming, and the sensor has been opened
prior to the arming. (message shown on main console)
•
Window opened
•
Window battery cover opened Door battery cover opened
Installing the Door/Window Detector
Installing for( DC 12V Detector):
To install a Door/Window Detector, follow these steps:
1. Before installing the sensor, ensure the sensor has programmed into the main console
successfully
2. Apply double sided adhesive tape to the back of the sensor.
3. Find the arrow embossed on the sensor, just below the LED light. Find a similar arrow
on the magnet. Before exposing the adhesive backing, align the two arrows on the
surface where you want them installed. Check that both parts of the device fit and that
they can be mounted with a gap less than 1/4 inch between them.(refer to the picture
below ).
4. Reconfirm the setting on the main console, Press the CHECK button, and then open
the window. The main console will receive the sensor signal and leave a message on
the LCD display for about 2 seconds . Note: Checking this will require two people
INSTALLING POSITION REFERENCE FOR DOOR/WINDOW DETECTOR
63 W INDOW SENSOR
01 Open
63 W INDOW SENSOR
01 Tamper
63 D O O R SENSOR
01 Tamper