Oki 12i - Manual (Page 4)

iv
Federal Communications Commission
Radio Frequency Interference Statement for
120-Volt Models
WARNING: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
It is the responsibility of the user to obtain the required shielded cable
in order to ensure compliance of this equipment with FCC regulations.
Changes or modifications not expressly approved by Okidata may void
your authority to operate this device.
Industry Canada
Radio Interference Statement for 120-Volt Models
This apparatus complies with the Class “B” limits for radio interference
as specified in the Industry Canada Radio Interference Regulations.
Cet appareil est conforme aux critères établis pour la Classe “B” en ce qui
concerne les interférences radio, tel que spécifié par Industry Canada dans
les Règlements relatifs aux Interférences Radio.
Federal Communications Commission
Radio Frequency Interference Statement for 230/240-Volt Models
WARNING: This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the
interference at his own expense.
It is the responsibility of the user to obtain the required shielded cable
in order to ensure compliance of this equipment with FCC regulations.
Changes or modifications not expressly approved by Okidata may void
your authority to operate this device.
Industry Canada Radio Interference Statement for
230/240-Volt Models
This apparatus complies with the Class “A” limits for radio interference
as specified in the Industry Canada Radio Interference Regulations.
Cet appareil est conforme aux critères établis pour la Classe “A” en ce qui
concerne les interférences radio, tel que spécifié par Industry Canada dans
les Règlements relatifs aux Interférences Radio.