Onkyo CR-505 - Manual (Page 24)

24
Using the Radio
1
Use the [INPUT] button, or the remote con-
troller’s INPUT [ ]/[ ] buttons to select
AM or FM.
1
Press and hold the TUNING [ ] or [ ]
button on the remote controller for more
than one second and then release it.
The CR-505 searches for the next station. Searching
stops when a station is found.
2
Use the TUNING [ ]/[ ] buttons for fine
tuning.
Note:
You can tune the radio with the remote controller only.
If you select the FM band:
When you’re tuned into a station, the Tuned and FM
STEREO indicators appear.
The FM band is searched in 0.05 MHz intervals.
If you select the AM band:
When you’re tuned into a station, the Tuned indicator
appears.
The AM band is searched in 9 kHz intervals.
■
Tuning into weak FM stations
If a station has poor signal strength, you may not be able to
tune into that station properly, or reception may be noisy. In
this case, switch the FM MODE to MONO, then tune the
band.
Switching the FM MODE to MONO:
1
Press the [MODE] button.
2
Use the [ ]/[ ] buttons to display “FM
MODE” and press [ENTER].
3
Use [ ]/[ ] to display “MONO” and
press [ENTER].
The FM STEREO indicator goes off and mono mode is
selected.
Using the buttons on the CR-505:
1. Press the [MENU] button.
2. Turn the [
] control until “FM MODE” appears on
the display and push the [ ] control.
3. Turn the [ ] control until “MONO” appears on the
display and push the [ ] control.
Listening to the Radio
Tuning the Radio
DIRECT
MUTING
--/---
7
8 9
10/0
4
5 6
2 3
1
CLOCK
CALL
TIMER
CLEAR
REPEAT
DISPLAY
SLEEP
MODE
ENTER
INPUT
STANDBY/ ON
INPUT /
ENTER
MODE
PRESET / TUNING /
STANDBY / ON INPUT MENU BASS TREBLE
PUSH TO ENTER
PRESET DIRECT PHONES
VOLUME
MIN MAX
/ MENU
INPUT
/
/
/
/