Onkyo CR-505 - Manual (Page 30)

30
Timers— Continued
You can turn timers on or off as necessary. This can be use-
ful when, for example, you’re on holiday and you don’t
want to be woken up by the timer that you normally use as
an early-morning radio alarm.
1
Press the [TIMER] button repeatedly to
select the timer that you want to turn off.
2
Use the Up/Down [ ]/[ ] buttons to select
“TIMER OFF.”
The timer is turned off, and the previous display reap-
pears after two seconds.
To turn a timer back on again, repeat this procedure
and use the Up/Down [ ]/[ ] buttons to select
“TIMER ON.”
You can check a timer’s settings as follows.
1
Press the [TIMER] button repeatedly to
select the timer that you want to check.
2
Press the [ENTER] button repeatedly to
cycle through the timer’s settings.
Note:
You can edit the selected timer’s settings as you check them.
To do this, use the Up/Down [ ]/[ ] buttons to edit the cur-
rently displayed setting, and then press [ENTER] to move
on to the next setting.
With the sleep timer you can set the CR-505 so that it auto-
matically turns off after a specified period.
1
Press the [SLEEP] button repeatedly to
select the required sleep time.
With the [SLEEP] button you can set the sleep time
from 90 to 10 minutes in 10 minute increments.
The SLEEP indicator appears on the display when the
sleep timer has been set, as shown. The specified sleep
time appears on the display for about five seconds, then
the previous display reappears.
To cancel the sleep timer, press the [SLEEP] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the
[SLEEP] button. Note that if you press the [SLEEP]
button while the sleep time is being displayed, you’ll
shorten the sleep time by 10 minutes.
Turning Timers Off
Checking Timer Settings
MUTING
--/---
7
8 9
10/0
4
5 6
2 3
1
CLOCK CALL
TIMER
CLEAR
REPEAT
DISPLAY
SLEEP
MODE
ENTER
INPUT
STANDBY/ ON
TIMER
ENTER
SLEEP
Using the Sleep Timer
SLEEP
SLEEP indicator