Onkyo CR-505 - Manual (Page 7)

7
Before Using the CR-505
1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AAA/
R03) in accordance with the polarity dia-
gram inside the battery compartment.
3
Close the battery compartment.
Notes:
• The supplied batteries should last for about six months,
although this will vary with usage.
• If the remote controller doesn’t work reliably, try replac-
ing both batteries.
• Don’t mix new and old batteries, or different types of bat-
teries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage and
corrosion.
• Drained batteries should be removed as soon as possible
to prevent possible leakage and corrosion.
To use the remote controller, point it at the CR-505’s remote
control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the CR-505
is subjected to bright light, such as direct sunlight or
inverter type fluorescent lights. Keep this in mind when
installing the CR-505.
• If another remote controller of the same type is used in
the same room, or the CR-505 is installed close to equip-
ment that uses infrared rays, the remote controller may
not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvertently,
thereby draining the batteries.
• The remote controller may not work reliably if the CR-505
is installed in a rack behind colored glass doors. Keep this
in mind when installing the CR-505.
• The remote controller will not work if there’s an obstacle
between it and the CR-505’s remote control sensor.
Installing the Remote Controller
Batteries Using the Remote Controller
CR-505
5 m
R C-5 80 S
Remote control
sensor