Omega Vehicle Security FPU5-MT-110 - Manual (Page 39)

5. Use the UP and DOWN ARROW keys to enter the RPM setting you desire.
Figure 6-2 shows the range of the RPM numbers you can work with.
Figure 6-2. RPM Range
5. Once the display shows the RPM setting you desire, press the START/STOP key.
As the fluid begins to dispense, the non-flashing display shows the actual RPM
value of the pump.
For details on how to prevent the tubing from moving through the pump,
refer to Section 6.5.
6. To stop pumping in the RPM Mode, simply press the START/STOP key again.
The pump stops running, and the display returns to the STOPPED Display
Mode
.
Table 6-1 shows how other keys and buttons can be used while pumping in the
RPM mode.
xxx RPM
START
STOP
ACTION
Pump(s) starts;
press again pump(s)
stops
Display
Range
ᮡ
10
11
12
.
.
.
599
600
Range
ᮢ
600
599
.
.
.
12
11
10
xxx RPM
ACTION
RPM setting scrolls down
ᮢ
Display shows
ACTION
RPM setting scrolls up
ᮡ
xxx RPM
Display shows
Operating the Pump Motor in the RUNNING Display Mode 6
6-2
NOTE