Omega Vehicle Security FPU5-MT-110 - Manual (Page 57)

6-20
Table 6-4 (cont’d) TOTAL VOLUME MODE
KEY DISPLAY ACTION TAKEN
SHOWS AND PROCEDURE
FLOW
RATE
TOTAL
VOLUME
xxx mL/min
or
xxx L/min
Displays actual FLOW RATE
Press the FLOW RATE key. The display flashes the calculated
fluid flow rate (xxx mL/min or xxx L/min).
xxx mL
or
xxx Liters
Displays current TOTAL VOLUME setting
1. Press the TOTAL VOLUME key. The display flashes the
TOTAL VOLUME setting you selected just before starting
the pump.
2. Use the UP and DOWN ARROW keys to enter the TOTAL
VOLUME setting you desire. As you use the UP and DOWN
ARROW keys, the display changes accordingly.
TUBE ID
CALIBRATE
TUBE ID=xxx
Displays current TUBE ID
Press the TUBE ID key. If the red LED next to the CALIBRATE
key is not lit, the display flashes the current TUBE ID setting. If
the red LED next to the CALIBRATE key is lit, the display flashes
the message “CALIBRATED TUBE!”.
CALIBRATED!
or
not calibrated
Displays calibration state
1. Press the CALIBRATE key. If the red LED next to the
CALIBRATE key is not lit, the display shows “not
calibrated”. If the red LED next to the CALIBRATE
key is lit, the display shows “CALIBRATED!”.
To calibrate a tube:
2.
Press the START/STOP key to stop the pump. The display
returns to the STOPPED Display Mode. For detailed
instructions on “Calibrating a Tube”, refer to Section 5.5.
ᮡ
and
ᮢ
xxx mL
or
xxx Liters
NOTE: if you press the UP and DOWN ARROW keys, the display
shows the current TOTAL VOLUME setting. This setting
changes accordingly as you use the UP and DOWN
ARROW keys.
NOTE: if you press the Language button, the display changes
to the next language in the sequence: English, French,
Spanish, German, and Italian. Language
Button