Omega Vehicle Security FPU5-MT-110 - Manual (Page 51)

6-14
Table 6-3 TIME MODE
KEY DISPLAY ACTION TAKEN
SHOWS AND PROCEDURE
xx:xx:xx
Pump motor’s power
NOTE: if you turn off the pump motor’s power, the pump stops
running.
To continue pumping, turn on the unit’s power. The display
returns to the STOPPED Display Mode and shows the time
elapsed during pumping. Then press the START/STOP key.
ON/OFF Switch
xx:xx:xx
Pump(s) stops; press again pump(s) starts
To resume pumping for the remainder of the TIME setting, press
the START/STOP key. The display enters the RUNNING Display
Mode, and the fluid begins to dispense.
Must STOP first! LEDs indicate new pump direction
To select the other inlet and reverse the direction of pumping:
1.
Press the START/STOP key. The display returns to the
STOPPED Display Mode.
2. Press the INLET SELECT key to reverse the direction of
pumping.
3. Press the START/STOP key again to resume pumping.
4. For detailed instructions on “Defining the Direction of
Pumping, refer to Section 5.2.
START
STOP
INLET
SELECT
STOP to Prime...
Pumps fluid at current rpm or flow rate
setting as long as the key is pressed
To prime a tube:
1.
Press the START/STOP key to stop the pump. The display
returns to the STOPPED Display Mode.
2. Press and hold down the PRIME key to prime the tube.
3. Press the START/STOP key again to resume pumping.
4. For detailed instructions on “Priming a Tube”, refer to
Section 5.4.
xxx °C Display alternates when pressed, °C then °F.
NOTE: The TEMP key functions the same whether the pump is
stopped or running. Refer to Section 5.6.
PRIME
TEMP
RPM
xxx rpm Displays actual RPM
Press the RPM key. The display flashes the actual pump motor
speed (xxx rpm).