Oki Pos 407II - Manual (Page 36)

–  –
Adjustment value according to the paper you are using
Paper thick-ness
(µm)
When using the paper roll with a core whose inside diameter (A):ø, outside diameter
(B):ø
Detected diameter (C)
(Approx. mm)
Remained paper length
(Approx. m)
Level  Level  Level  Level  Level  Level 
6 ш ш ш . . .
 . . 6.
Paper thick-ness
(µm)
When using the paper roll with a core whose inside diameter (A): ø., outside di-
ameter (B):ø
Detected diameter (C)
(Approx. mm)
Remained paper length
(Approx. m)
Level  Level  Level  Level  Level  Level 
6 ш6 ш0 ш . 6. 0.
 . . .0
 . . .
 . . .
0 . .0 6.
0 . . .
0 . . .
Note:
) The adjuster is factory-set at level  on the horizontal
layout and level  on the vertical/wall-mount lay-
out.
) The control switch or the memory switch A may be
used to switch between the horizontal and vertical
(wall-mount) layouts. For instructions on setting the
memory switch, refer to the separate Specifications
Manual.
) The detected diameter and remained paper length
given above are calculated values, and there may be
some variances depending on the rolled state of the
paper or the actual mechanism.
) If thick paper is used (paper thickness between 00
μm and 150 μm), the paper roll may loosen and cause
variances in the detected values. Therefore, set the
adjustor to Level  for horizontal layout.
C
C
B
A
Paper roll core