Oki Pos 407II - Manual (Page 50)

– 6 –
11-3. USB Interface Model
ON ON
OFF OFF
DIP-SW 
Switch Function ON OFF
- Command emulation (Ster Line mode) Always ON
- Should not be changed (Should be set to on)
- Should not be changed (Should be set to on)
- Sensor adjustment Invalid Valid
- USB mode Printer class Vendor class
-6 Handshaking conditions (conditions for
BUSY)
Offline or receive
buffer full
Receive buffer full
- Automatic status back function * Invalid Valid
- Should not be changed (Should be set to on)
- Low-power consumption mode Invalid Valid
-0 Should not be changed (Should be set to on)
* Automatic status back function is disabled when USB mode is Printer Class (switch - =
ON).
The factory settings of DIP switch are all on.
DIP-SW 
Switch Function ON OFF
-~- Always ON Should be set to on
The factory settings of DIP switch are all on.
No. 1 2 3 4 5 6 7 8 No. 1 2 3 4 9 10
DIP-SW 1 DIP-SW 2