Oki Pos 407II - Manual (Page 44)

– 0 –
11. Dip Switch Setting
Two DIP switches are provided at the bottom of the printer, and can be set as given in the table
below. Be sure to set the power switch to off before changing the settings. It is recommended
to use a pointed item like a pen or flat-blade driver screw to change the settings. The settings
will become effective when the power switch is set to on again.
The following is the procedure for changing the settings on DIP switches.
. Make sure the printer is turned off.
. Remove the screw from the DIP switch blind. Then take off the DIP switch blind, as shown
in the illustration below.
3. Set the switches using a pointed tool, such as a pen or flat-blade screwdriver.
. Replace the DIP switch blind. Then secure it with the screw.
The new settings take effect when you turn on the printer.