Onkyo HT-RC180 - Manual (Page 135)

135
Controlling Other Components
—Continued
Here are the default settings.
Source Play
Enable: Start playback the source
of “Enable”.
Disable: Start playback the source
of “Disable”.
This option enables the Source to
start playback when the ACTIVI-
TIES button is pressed.
item
Default Settings
My
Movie
My TV
My
Music
Source DVD CBL CD
TV Power On Enable Enable Disable
Source Power On Enable Enable Enable
Receiver Power On Enable Enable Enable
Receiver Source
Change
Enable Enable Enable
Source Play Enable Disable Enable
6 Press [ENTER].
A message for transfer will appear.
To use the remote controller, point it at
the AV receiver’s remote control sen-
sor, as shown below.
8–2. Activities Setup My Movie
OK
Now we are ready to transfer data to Remote
Please hold remote so that it is facing the receiver.
Use ENTER button of your remote to activate “OK”.
Ready?
15
15
AV receiver
Approx.
16ft. (5 m)
Incoming sensor
Transmitter
15° off center
(Left/Right/Up/Down)
7 On the remote controller press
the [ENTER] button.
When the transfer is successful, the fol-
lowing screen appears.
8 When you’ve finished, press the
[ENTER] button.
The “8-2. Activities Setup” menu
appears onscreen.
9 When you’ve finished, press the
[SETUP] button.
The setup menu closes.
8–2. Activities Setup My Movie
Wait
8–2. Activities Setup My Movie
Return
Successful
TX-NR807_En.book Page 135 Tuesday, July 28, 2009 12:00 PM