Onkyo HT-RC180 - Manual (Page 47)

47
First Time Setup
—Continued
Notes:
• See page 27 for charts showing how the “Monitor
Out” and “Resolution” settings affect the video signal
flow through the AV receiver.
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
5 Use the Up and Down [ ]/[ ] but-
tons to select “Resolution”, and
use the Left and Right [
]/[ ]
buttons to select:
Through:
Select this to pass video through the
AV receiver at the same resolution
and with no conversion.
Auto :
Select this to have the AV receiver
automatically convert video at reso-
lutions not supported by your TV.
480p (480p/576p):
Select this for 480p or 576p output
and video conversion as necessary.
720p:
Select this for 720p output and
video conversion as necessary.
1080i:
Select this for 1080i output and
video conversion as necessary.
1080p :
Select this for 1080p output and
video conversion as necessary.
Tip:
The “Resolution” setting can also be set
using the [VIDEO] button on the
remote controller.
Note (TX-NR807):
Settings marked with an asterisk ( )
are not available when the “Monitor
Out” setting is set to “Analog”.
6 Press the [SETUP] button.
The setup menu closes.
*
*
*
TX-NR807_En.book Page 47 Tuesday, July 28, 2009 12:00 PM