Onkyo HT-RC180 - Manual (Page 43)

43
First Time Setup
This section explains the settings that you need to make before using the AV receiver for the very first time.
If you connect your TV to the HDMI OUT, “Monitor
Out” setting is automatically set to “HDMI” so that the
onscreen setup menus are displayed and composite
video, S-Video, and component video sources are
upconverted* and output by the HDMI OUT. The
onscreen setup menus are displayed on the HDMI OUT
only.
On the “Monitor Out” settings, you can select whether or
not to have the video sources’ images output through the
HDMI OUT, as well as whether to have the onscreen
setup menu output through the HDMI OUT or through
an analog output.
If you connect your TV to the COMPONENT VIDEO
MONITOR OUT (not the HDMI OUT), “Monitor Out”
setting is automatically set to “Analog” so that the
onscreen setup menus are displayed and composite
video and S-Video sources are upconverted* and output
by the COMPONENT VIDEO MONITOR OUT.
■ Change “Monitor Out” setting manually
Tips:
• The “Monitor Out” setting can also be set using the
[VIDEO] button on the remote controller.
• This setting can also be performed by using Onscreen
Setup Menu (see page 46).
Notes:
• See page 27 for charts showing how the “Monitor
Out” and “Resolution” (see page 46) settings affect
the video signal flow through the AV receiver.
• You can specify the output resolution for the HDMI
OUT and COMPONENT VIDEO MONITOR OUT
and have the AV receiver upconvert the picture
resolution as necessary to match the resolution
supported by your TV (see page 46).
Monitor Setup (TX-NR807)
IN
OUT
Composite video, S-Video,
component video
Composite video, S-Video,
component video
HDMI
HDMI
IN
OUT
Composite video, S-Video
Composite video, S-Video
Component video
Component video
1 Press the [MONITOR OUT] but-
ton.
The current setting is displayed.
2 Press the [MONITOR OUT] button
repeatedly to select:
Analog: Select this if your TV is con-
nected to the COMPONENT
VIDEO MONITOR OUT, S
MONITOR OUT, or V MON-
ITOR OUT.
HDMI: Select this if your TV is con-
nected to the HDMI OUT.
Note:
When “HDMI” is selected, the
onscreen setup menus are output by
only the HDMI OUT. If you’re not
using the HDMI OUT and select
“HDMI” by mistake and the menus
disappear, press the [MONITOR
OUT] button to select “Analog”.
MONITOR OUT
TX-NR807_En.book Page 43 Tuesday, July 28, 2009 12:00 PM