On-Q/Legrand REV.O 1307877 - Manual (Page 11)

Page 7
301 Fulling Mill Road, Suite G ©Copyright 2005 by On-Q/Legrand, Inc All Rights Reserved.
Middletown, PA 17057 www.onqlegrand.com
(800)-321-2343
4. In the structured wiring enclosure (see Figure 10) the Cat 5e from the WAP 802.11g can be
terminated with an RJ45 plug which is then connected directly to the output of the Power over
Cat 5e Inserter Module (P/N 36488-01).
5. A supplied Cat 5e patch cable is then connected from the input RJ-45 jack of the Power over
Cat 5e Inserter Module to one of the LAN ports on the On-Q or third party Router, or directly
to a Broadband Modem.
6. The Power over Cat 5e Inserter Module is powered with a 24 Volt DC power supply which
needs to be plugged in to an AC source.
7. When the 24 VDC Power Supply is plugged in to an active AC Source, verify that the Power
LED is lit on the Power Inserter.
8. Next, verify that the Power LED is lit on the WAP.
9. If you connected to an active network, verify that the Network Activity LED is lit on the
network access device and on the WAP.
10. Then, verify the Wireless LED is lit on the WAP.
Figure 10 Data/Power
out to WAP Data in from ISP
Cat 5e
patch cable
Power Over
Cat5e Inserter
Module
Router/
Switch