Oki S700 - Manual (Page 56)

APPENDIX A - PRINTER PROFILE UTILITY > 56
APPENDIX A - PRINTER PROFILE UTILITY
When you take delivery of your S700 Scancopier it is already loaded
with the correct range of Printer Profiles and firmware and you should
therefore not normally require to use the Printer Profile Utility.
However, in the unlikely event that you require to update either the
printer profiles or the firmware, you can use the Printer Profile Utility
to do this.
If the USB cable supplied with your Scancopier is not already
connected between your PC and Scancopier, switch off both devices,
connect the USB cable between them and switch on both devices
again.
PRINTER PROFILE UPDATE
1. Use Start>Programs>S700 Scancopier Printer Profile
Utility>S700
Scancopier Printer Profile Utility to show the
Scancopier printer Profile Utility window (example below).
NOTE
The default folder associated with the Printer Profile Utility is
C:\Program Files\S700 Scancopier Printer Profile Utility\Supported
Printer Profiles\S700\OkiData\.