On-Q/Legrand HMS 1100 - Manual (Page 39)

Page 31
Message
To show, log, clear, and send text messages, and to say and phone (dial out) your voice messages, press the 8 (MESSAGE) key:
MESSAGE
1=SHOW 2=LOG 3=CLEAR ↓
4=SAY 5=PHONE 6=SEND
↑
Show Message
The 1 (SHOW) key allows you to display the selected text message(s) on the console's top-level display. This can be a helpful
reminder of special events and occasions.
TRASH
NIGHT
ENTER MESSAGE ↓
You may enter the message number followed by the ' # ' key to display that message, or simply press the down arrow key to scroll
through a list of messages. Press the ' # ' key to display the selected message:
Thu Oct 04, 01 4:06 PM
TRASH NIGHT
When the message is displayed, the console will beep 4 times and the console LED will flash continuously. You may press the
' * ' key to acknowledge seeing the message. This will cause the LED to stop flashing, however, the message will remain on the
display until it is manually cleared, or cleared by a program.
Log Message
The 2 (LOG) key allows you to store the selected text message(s) in the Event Log. This can be a helpful to keep track of the
times and dates of events and occurrences.
You may enter the message number followed by the ' # ' key to log that message, or simply press the down arrow key to scroll
through a list of messages. Press the ' # ' key to log the selected message.
Clear Message
The 3 (CLEAR) key allows you to clear the selected text message, or all text messages from the console's display.
TRASH
NIGHT
ENTER MESSAGE 0=ALL ↓
You may enter the message number followed by the ' # ' key to clear that message, or simply press the down arrow key to scroll
through a list of messages. Press the ' # ' key to clear the selected message, or press 0, then ' # ' to clear all messages.
Say Message
Note: To Say a message, the HMS Two-Way Audio Module (with a speaker) must be installed.
The 4 (SAY) key allows the controller to say the selected voice message over a speaker. This voice message can be an audible
reminder of special events and occasions.
You may enter the message number followed by the ' # ' key to say that message, or simply press the down arrow key to scroll
through a list of messages. Press the ' # ' key to say the selected message.