Oki OFFICE 87 - Manual (Page 24)

24 OKIOFFICE 87 Setup Guide
Tip: In some countries, the Telephone Answering Device mode is
turned off. To have it turned on, contact your dealer.
Memory Reception Mode [MEM]: The received data is not printed
and is stored into memory even if there is fax paper on which to print.
Use the Print Operation function when you want to print out data that
was stored in memory during the Memory Reception mode.
You can set a password for when you want to disable the Memory
Reception mode.
The password is set by USER PROGRAMMING under MEM. PASS-
WORD PRG.
PC Receive mode [PC]: Use this mode when your MFP machine is
connected to your PC. The call signal from your exchange is sent
directly to your PC. Your MFP machine does not respond to the signal.
Fax reception by your PC is enabled upon receiving the call signal.
Tip: You need to install a special driver into your PC in order to use
this function.
Forwarding Mode [FWD]: The forwarding mode allows received
facsimiles to be forwarded to another number. The forwarding numbers
are entered or registered at One-Touch key 6. Up to ten forwarding
numbers can be registered.
Changing the Answering Mode
Follow these instructions to change your MFP machine’s answering
mode.
1 Press the AUTO REC key. Your MFP machine displays a descrip-
tion of your current selection.
2 Press the AUTO REC key again. Your MFP machine switches to the
next setting.
3 Continue pressing the AUTO REC key until the selection you want
appears on the display. After a short pause, your MFP machine
returns to standby mode displaying the new answering mode
setting.
Tip: If a password has been set in the Memory Reception mode,
you need to enter the password in order to disable the Memory
Reception mode.