Oki OFFICE 87 - Manual (Page 4)

4 OKIOFFICE 87 Setup Guide
Operation and Maintenance
- Aside from the instructions specifically stipulated in the handbook,
do not attempt to disassemble or service this machine, including the
lubrication of moving parts. Please contact an authorized service
center for assistance.
- Use a soft dry cloth to clean the control panel and main body of the
unit. Do not apply any cleanser to the cloth or surface of the ma-
chine.
- Remove the power cord from the wall socket before trying to re-
cover any object(s) that may have fallen into the machine.
- If the machine is physically damaged, immediately disconnect it and
arrange for its repair or disposal.
- When moving the machine, always disconnect the telephone line
before disconnecting the power cord. Accordingly, reconnect the
power cord before reconnecting the telephone line.
- This machine is not intended for use in parallel with any other
telephone devices.
Toner Cartridge and Image Drum Unit
Warning: This OKI facsimile machine will not operate if any toner
cartridge or image drum unit other than that specified by
OKI is installed. Please be sure to read the labeling on
the toner package and image drum unit package to
ensure that you have purchased the correct cartridge or
unit. The installation of any other toner cartridge or
image drum unit will cause the system to lock, and the
operations panel will display an error.
- Leave unused toner cartridges and image drum units sealed in their
packaging until needed. When replacing a toner cartridge or image
unit, re-use the packaging to dispose of the old toner cartridge or
image drum unit.
- Do not expose interior components of the machine to light for more
than five minutes. Never expose the green drum (located inside the
image drum unit) to direct sunlight.
- Please be careful when handling the image drum unit and only
touch it at the ends (never in the middle). Never touch the green
drum inside the image drum unit.