Onkyo AV RECEIVER HT-R8230 - Manual (Page 30)

30
Using the audio adjust functions
Before operating the remote controller, press RCVR/TAPE.
These functions only work with speaker system A.
Audio Adjust provides various functions for adjusting the sound,
including several especially for use with Dolby Digital, DTS, and
Pro Logic II source.
The following table lists the Audio Adjust functions, their ranges
and default values. Function availability depends on the current
source and listening mode, as listed in the “The input source and
available listening mode” column. See page 29 for information on
listening modes.
Audio adjust function
AUDIO ADJUST
PRESET/ADJUST
AUDIO ADJUST
CINE FLTR
LATE NIGHT
ADJUST
1. Press AUDIO ADJUST (repeatedly) until the
item to be adjusted is displayed.
2. Press PRESET/ADJUST / on the unit or
ADJUST / on the remote controller to adjust
the item.
Refer to the right column for AUDIO ADJUST items and
settings.
Note
Cinema Filter and Late Night can also be adjusted from the
remote control.
Press the CINE FLTR or LATE NIGHT button to display the
current setting (On or Off). To change the current setting, press
the same button again.
Value or setting
Remote controller Remote controller
Function Range Default Supported
listening mode
Bass –12 dB to +12 dB
0 dB
All modes except
Treble in 2 dB steps Direct
Late Night Low, High, Off Dolby Digital
Cinema
Pro Logic II Movie
Filter On, Off
Off Dolby Digital
(Cine Fltr)
DTS
DTS Neo:6 Cinema
Panorama On, Off Off
Dimension 0, 1, 2, 3, 4, 5, 6
Pro Logic II Music
Center 0, 1, 2, 3, 4, 5, 6, 3
Width 7
Item
Before operating the
remote controller,
press RCVR/TAPE.