Onkyo AV RECEIVER HT-R8230 User Manual
Page 33
33
Using the remote controller with your other AV
components
Connecting your Onkyo CD player, Onkyo DVD player, or Onkyo
cassette recorder to the HT-R8230’s
connector allows you to
control it with the HT-R8230’s remote controller. Since you only
need to point the remote controller at the HT-R8230, you can
control components that are out of sight, for example, in a cabinet.
Since you don’t have to enter any special codes, or do any
programming,
allows you to control your Onkyo AV
components quickly and easily. See page 16 for connection
information.
Using the RC-479S
1. Point the remote controller at the HT-R8230 and
use the input selector button to select an input
source for the HT-R8230.
2. Use the remote controller’s mode buttons (i.e.,
DVD, CD, RCVR/TAPE) to select a remote
controller mode.
(You don’t have to point the remote controller at anything for
this step.)
3. Use the remote controller’s Power
button to
turn on the AV component. Point the remote
controller at the HT-R8230.
(A cassette recorder can’t be turned on or off from the remote
controller. You must use its POWER switch.)
4. Use the buttons as explained below.
In the following illustrations, buttons that control the HT-
R8230 regardless of which mode is selected are shaded. When
you want to control the HT-R8230 fully, press the RCVR/
TAPE button, then you can use all the buttons that apply to the
HT-R8230.
:
Power On/Off.
:
Starts playback of DVD.
:
Stops playback.
:
Searches the disc in the forward direction.
:
Searches the disc in the reverse direction.
:
Lets playback pause temporarily or advances the
disc frame by frame.
:
Starts playback from the beginning of the next
chapter/track.
:
Starts playback from the beginning of the current
chapter/track.
DISC :
This button is valid when the DVD changer is used
and selects the disc to be played.
1–9, +10, 0 :
Use to enter numeric values.
TOP MENU : Displays the top menu of each DVD disc.
MENU :
Displays a menu recorded in the DVD disc.
RETURN :
Returns to the previous menu.
SETUP :
Displays the setup menu.
/ /
/
: Selects an item in a menu.
ENT :
Enters the selection in memory.
4.
DVD
operation
buttons
1.
DVD input
selector
2.
DVD
DVD mode
3.