Onkyo TXSR307 - Manual (Page 54)

54
Advanced Setup
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
This section explains how to check the speaker settings and how to set them manually, which is useful if you change a
speaker after performing the Audyssey 2EQ™ Room Correction and Speaker Setup.
Some of the speaker settings are set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function
(see page 33).
Common Procedures in Setup Menu
SETUP
RECEIVER
ENTER
Number
Buttons
Remote
indicator 1 Press the [RECEIVER] button followed by
the [SETUP] button.
2 Use the Up and Down [ ]/[ ] buttons to
select the function, and then press the
[ENTER] button.
3 Use the Up and Down [ ]/[ ] button to
select item, and then use the Left and
Right [
]/[ ] buttons to set them.
4 When you’ve finished, press the [SETUP]
button.
Setup closes.
Speaker Settings
3. Sp Config (Speaker Configuration)
These settings are set automatically by the Audyssey 2EQ Room Correction and Speaker
Setup function (see page 33).
This section explains how to specify which speakers are connected and their sizes.
For speakers with a cone diameter larger than 6-1/2 inches (16 cm), specify Large (full
band). For those with a smaller diameter, specify Small (default crossover 150Hz).
The crossover frequency can be changed on page 55.
Note:
Speaker Configuration, Crossover Frequency, and Double Bass settings cannot be changed
while headphones are connected, or speaker set B is on.
Subwoofer Yes: Select if a subwoofer is connected (default).
No: Select if no subwoofer is connected.
Front
*1 Small: Select if the front speakers are small (default).
Large: Select if the front speakers are large.
Center
*2 Small: Select if the center speaker is small (default).
Large: Select if the center speaker is large.
None: Select if no center speaker is connected.
Surround
*2 Small: Select if the surround speakers are small (default).
Large: Select if the surround speakers are large.
None: Select if no surround speakers are connected.
*1 If the “Subwoofer” setting is set to “No”, this setting is fixed at “Large” and does not appear.
*2 If the “Front” setting is set to “Small”, the “Large” option cannot be selected.
Cone diameter