Onkyo TXSR307 - Manual (Page 62)

62
Controlling Other Components
You can control your DVD player, CD player, and other
components with the AV receiver’s remote controller.
To control another component, you must first enter that
component’s remote control code to a REMOTE MODE
button.
This section explains how to enter remote control codes
and how to control your other components.
The following REMOTE MODE buttons are
preprogrammed with remote control codes for
controlling the components listed. You do not need to
enter a remote control code to control these components.
For details on controlling these components, see the
pages indicated.
Onkyo DVD/BD player (page 64)
Onkyo CD player (page 65)
Onkyo RI Dock with
(page 66)
You’ll need to enter a code for each component that you
want to control.
Note:
The remote control codes provided are correct at the time
of printing but subject to change.
Preprogrammed Remote Control
Codes
Entering Remote Control Codes
RECEIVER
DISPLAY
REMOTE
MODE
AUDIO
Number
buttons
Remote
indicator
1 See page 63 for the Onkyo
component’s remote control
code.
2 While holding down the REMOTE
MODE button to which you want
to enter a code, press and hold
down the [DISPLAY] button until
the Remote indicator lights up
(about 3 seconds).
Notes:
• Remote control codes cannot be
entered for the [RECEIVER]
buttons.
• Apart from the [RECEIVER] button,
remote control codes from any
category can be entered for the
REMOTE MODE buttons. However,
these buttons also work as input
selector buttons (page 38), so choose
a REMOTE MODE button that
corresponds with the input to which
you connect your component. For
example, if you connect your CD
player to the CD input, choose the
[CD] button when entering its remote
control code.
3 Within 30 seconds, use the
number buttons to enter the 5-
digit remote control code.
The Remote indicator flashes twice.
If the remote control code is not entered
successfully, the Remote indicator will
flash once slowly.
(3 seconds)