Onkyo TXSR307 - Manual (Page 60)

60
Advanced Setup
—Continued
You can change various audio settings by pressing the [AUDIO] button.
Using the Audio Settings
RECEIVER
AUDIO
1 Press the [RECEIVER] button followed by
the [AUDIO] button.
2 Use the Up and Down [ ]/[ ] buttons to
select an item.
3 Use the Left and Right [ ]/[ ] buttons to
change the setting.
Repeat this step for the other settings.
Tone Control Settings
You can adjust the bass and treble for the front speakers, except when the Direct listening mode is selected.
Notes:
• To bypass the bass and treble tone circuits, select the Direct listening mode.
• This procedure can also be performed on the AV receiver by using its [TONE], [–], and [+] buttons.
Bass –10dB to +10dB in 2dB steps (default: 0dB)
Treble –10dB to +10dB in 2dB steps (default: 0dB)
Late Night Function
With the Late Night function, you can reduce the dynamic range of Dolby Digital material so that you can still hear
quiet parts even when listening at low volume levels—ideal for watching movies late at night when you don’t want
to disturb anyone.
Notes:
• The Late Night function can be used only when the input source is Dolby Digital.
• The effect of the Late Night function depends on the material that you are playing and the intention of the original
sound designer, and with some material there will be little or no effect when you select the different options.
• The Late Night function is set to Off when the AV receiver is set to Standby.
Late Night Off: Late Night function off (default).
Low: Small reduction in dynamic range.
High: Large reduction in dynamic range.
CinemaFILTER
With the CinemaFILTER, you can soften overly bright movie soundtracks, which are typically mixed for
reproduction in a movie theater.
CinemaFILTER can be used with the following listening modes: Dolby Digital, Dolby Pro Logic II Movie, DTS,
DTS 96/24, and Neo:6.
Note:
The CinemaFILTER may not work when used with certain input sources.
Cinema Fltr Off: CinemaFILTER off (default).
On: CinemaFILTER on.