Oricom TCR10 - Manual (Page 6)

3.6 Connecting to the telephone socket
Connect the telephone cable supplied to the telephone wall socket and to the
socket marked with a “PHONE LINE” symbol on the rear of the base unit.
3.7 Recall button
You will use the Recall button when using your network operator’s services such
as call waiting etc. If this feature is not working check the position of the Recall
switch on the side of the phone. In Australia it should be set at 100ms and in
New Zealand 600ms
3.8 Setting the Time
After the unit is connected to power, the LCD turns on and the display starts the
clock at “12:00”. If you want to set the clock to the current time, proceed as
follows:
1. Press the TIME SET button. The clock digits will be flashing.
2. Now press UP/HOUR button to increment the clock digit.
3. Press DOWN/MIN button to increment the minute digit.
4. After the clock displays a correct time, press TIME SET button again to
confirm. The clock digits stop to flash and commerce counting.
3.9 Setting the FM antenna
In order to enjoy the best possible radio reception performance, you must uncoils
the FM antenna on the rear of the unit. This wire is bound with a cable tie. Undo
the cable tie and fully extend the FM antenna to achieve the best reception.
4 Operation
4.1 Setting the clock alarm
You can choose to wake from two types of alarm, RADIO or BUZZER ALARM.
Use the switch on the back of the phone to Select RADIO (radio alarm) or BUZZ
(buzzer alarm). To set the clock alarm, proceed as follows:
1. Press the ALARM SET button. The icon and clock digits will be flashing.
2. Now press UP/HOUR button to increment the clock digit.
3. Press DOWN/MIN button to increment the minute digit.
4. After the LCD displays a correct alarm time, press ALARM SET button again
to confirm. The clock digits stop to flash and return to clock display.
6