Onkyo Network TX-8050 - Manual (Page 19)

En-
19
Enjoying Audio Sources
1 Rotate the receiver’s [INPUT] selector, or
press the remote controller’s INPUT
SELECTOR buttons to select the source
you want to hear.
2 Use the [SPEAKERS A] and [SPEAKERS B]
buttons on the receiver to select the
speaker set that you want to use.
The A and B speaker indicators show whether each
speaker set is on or off.
3 Start playback on the selected component.
4 To adjust the volume, use the receiver’s
[VOLUME] control, or the remote
controller’s VOLUME []/[] buttons.
Turn the control clockwise to turn up the volume or
counterclockwise to turn down the volume.
You can temporarily mute the output of the receiver.
Press the remote controller’s [MUTING] button.
The receiver is muted.
To unmute the receiver, press the [MUTING]
button again.
Note:
The Mute function will be cancelled if the remote
controller’s [VOLUME] buttons are pressed or the
receiver is set to Standby.
You can connect a pair of stereo headphones (1/4-inch
phone plug) to the receiver’s PHONES jack for private
listening.
Notes:
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the PHONES
jack, the speakers are turned off.
• If you connect an iPod or iPhone to the USB port on
this device, no sound will be output from the
headphones jack.
VOLUME
INPUT PHONES
INPUT
SELECTOR
VOLUME F/H
MUTING
SPEAKERS A, B
A,B Indicators
Muting the Receiver
(remote controller only)
Using Headphones