Onkyo TX-DS787 - Manual (Page 45)

45
4-2. Headphones Level sub-menu
You can use this sub-menu to adjust the volume output from the
headphones so that it matches the level output from the speakers.
The headphone volume can be adjusted between –12 and +12
decibels.
4-3. DTS LFE Level Setup sub-menu
This sub-menu is used to set the LFE level for the playback of DTS
sources. Normal playback is at 0 decibels; however, for some
music software where the bass sounds are played back at high
volumes, you can set this setting to –10 decibels.
Preference
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
4.Preference
1.Volume Setup
2.Headphones Level
3.DTS LFE Level Setup
4.Powered Zone2 Setup
|ENTER| Quit:|OSD|
4.Preference
1.Volume Setup
2.Headphones Level
3.DTS LFE Level Setup
4.Powered Zone2 Setup
|ENTER| Quit:|OSD|
4.Preference
1.Volume Setup
2.Headphones Level
3.DTS LFE Level Setup
|ENTER| Quit:|OSD|
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
4.Preference
1.Volume Setup
2.Headphones Level
3.DTS LFE Level Setup
4.Powered Zone2 Setup
|ENTER| Quit:|OSD|
4-1.Volume Setup
a.Volume Display
:Absolute
b.Maximum Volume
:Off
c.Power on Volume
:Last
Quit:|OSD|
4-1. Volume Setup sub-menu
This sub-menu allows you to make various settings concerning the
volume control of the TX-DS787.
a. Volume Display
You can choose from two ways of displaying the volume setting
on screen.
Absolute: This displays the volume with a minimum of min
(0) for no sound and a maximum of max (80). As a reference,
the volume setting of Ref (62) is used as the 0 -decibel for the
relative display method.
Relative: This displays the volume as a decibel value on a
scale with a designated reference point that is displayed as 0,
which equals the volume setting of 62 for the absolute display
method. With this display method, the minimum value is –
∞,
the next highest is –61, and the maximum value is +18.
b. Maximum Volume
This setting allows you to set the maximum volume that can be
output with the MASTER VOLUME dial to prevent components
from being damaged by excessively loud volumes. For the
absolute volume display method, this can be set between 30 and
79. For the relative volume display method, this can be set
between –32 and +17 decibels.
c. Power On Volume
This sets a designated volume setting for the TX-DS787 to be set
every time that the power is turned on. This prevents the TX-
DS787 from being turned on while it is set to an extremely high
volume and suddenly output very loud sounds. For the absolute
volume display method, this can be set between min and max. For
the relative volume display method, this can be set between –
∞
and +18 decibels. If you do not mind having the TX-DS787 turned
on with its current volume setting, set this to “Last.”
4. Preference menu