Onkyo TX-DS787 - Manual (Page 46)

46
5. OSD Setup menu
This menu provides settings for you to customize the on-screen
display (OSD) for the TX-DS787 by setting different colors or
positions for its display.
OSD Setup
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
5.OSD Setup
1.OSD Config
2.OSD Setup
3.OSD Position
|ENTER| Quit:|OSD|
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
5.OSD Setup
1.OSD Config
2.OSD Setup
3.OSD Position
|ENTER| Quit:|OSD|
5-1.OSD Config
a.OSD Output :S Video
b.TV Format :Auto
Quit:|OSD|
5-1. OSD Config sub-menu
a. OSD output
This setting allows you to set the output of the OSD Menu. Select
the video terminal to which your monitor is connected: “S
VIDEO” or “VIDEO.”
S Video: Outputs the OSD Menu through the S VIDEO
MONITOR OUT terminals.
Video: Outputs the OSD Menu through the VIDEO
MONITOR OUT terminals.
Note:
If the OSD Menu is not displayed on the television monitor you are
using, confirm whether the television is connected to an S VIDEO
MONITOR OUT terminal or VIDEO MONITOR OUT terminal.
b. TV format
(For all models other than USA and Canadian models)
The default setting is “Auto,” which means that the television
format is detected and automatically set by the TX-DS787.
However, if you know the correct format, you can use this setting
to choose either PAL or NTSC so that no time is wasted on
detection.