Front & rear panels —continued – Onkyo TX SR507 User Manual
Page 12
12
HDMI IN 1–4 and OUT
HDMI (High Definition Multimedia Interface)
connections carry digital audio and digital video.
The HDMI inputs are for connecting components
with an HDMI output, such as a DVD/BD player,
DVD/BD recorder, or DVR (digital video recorder).
They’re assignable, which means you can assign
each one to an input selector to suit your setup. See
“HDMI Input Setup” on page 41.
The HDMI outputs are for connecting a TV or
projector with an HDMI input.
AM and FM ANTENNA
The AM push terminals are for connecting an AM
antenna. The FM jack is for connecting an FM
antenna.
MONITOR OUT
The composite video jack should be connected to a
video input on your TV or projector.
UNIVERSAL PORT (34)
This jack is for connecting the component with the
Universal Port connector such as UP-A1 series
Dock.
FRONT L/R, CENTER, and SURR L/R
SPEAKERS
These terminal posts are for connecting the front
speakers, center, and surround speakers.
REMOTE CONTROL
This
(Remote Interactive) jack can be
connected to the
jack on another
-capable
Onkyo component for remote and system control.
To use
, you must make an analog audio
connection (RCA) between the AV receiver and the
other component, even if they are connected
digitally.
CD IN
This analog audio input is for connecting a CD
player’s analog audio output.
TV/TAPE IN/OUT
These analog audio input and output jacks are for
connecting a recorder with an analog audio input
and output, such as a cassette deck, MD recorder,
etc.
CBL/SAT IN
A cable or satellite receiver can be connected here.
There is composite video input jack for connecting
the video signal, and there are analog audio input
jacks for connecting the audio signal.
VCR/DVR IN/OUT
A video component, such as a VCR or DVR, can be
connected here for recording and playback. There is
composite video input and output jack for
connecting the video signal, and there are analog
audio input jacks for connecting the audio signal.
DVD/BD IN
This input is for connecting a DVD/BD player.
There is composite video input jack for connecting
the video signal.
ZONE 2 LINE OUT L/R
These analog audio outputs can be connected to the
line inputs on amplifiers in Zone 2.
PRE OUT: SURR BACK L/R (TX-SR507 only)
This analog audio output can be connected to the
analog audio input on another power amplifier.
SUBWOOFER PRE OUT
This analog audio output can be connected to a
powered subwoofer.
SURR BACK L/R SPEAKERS (TX-SR577
only)
These terminal posts are for connecting the
surround back L/R speakers.
The FRONT L/R and SURR BACK L/R terminal
posts can be used with front speakers and surround
back speakers, respectively, or used to bi-amp front
Speakers. See “Bi-amping Front Speakers
(TX-SR577 only)” on page 19.
The SURR BACK L/R terminals can be used to
connect the front high L/R speakers. See “Speaker
Settings” on page 40.
ZONE 2 SPEAKERS L/R
These push terminals are for connecting speakers in
Zone 2.
FRONT HIGH L/R speakers (TX-SR577 only)
These terminals are for connecting the front high
L/R speakers.
The FRONT HIGH L/R terminal can be used with
front high speakers respectively, or used to connect
the speakers in Zone 2. See “Connecting Zone 2” on
page 80.