Onkyo TX SR507 - Manual (Page 69)

69
Advanced Setup
—Continued
2-3. Sp Distance (Speaker Distance)
These settings are set automatically by the Audyssey 2EQ
™ Room Correction and Speaker Setup function
(see page 37).
With these settings, you can specify the distance from each speaker to the listening position.
Measure and make a note of the distance from each speaker to the listening position.
Notes:
• Speakers that you set to “No” or “None” in the “2-2. Sp Config (Speaker Configuration)” (page 66 or 68) cannot be
selected.
• The speaker distance setting cannot be changed while a pair of headphones is connected.
• (TX-SR507) The Center and Subwoofer distances can be set up to 5 ft. (1.5 m) more or less than the Left distance.
For example, if the Left distance is set to 20 ft. (6 m), the Center and Subwoofer distances can be set between 15 and
25 ft. (4.5 and 7.5 m).
• (TX-SR577) The Center, Subwoofer and Front High distances can be set up to 5 ft. (1.5 m) more or less than the
Left distance. For example, if the Left distance is set to 20 ft. (6 m), the Center, Subwoofer, Front High Left and
Front High Right distances can be set between 15 and 25 ft. (4.5 and 7.5 m).
• The Surround and Surround Back distances can be set up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less than the Left
distance. For example, if the Left distance is set to 20 ft. (6 m), the Surr Right, Surr Left, Surr Back R, and Surr Back
L distances can be set between 5 and 25 ft. (1.5 and 7.5 m).
Unit feet: Distances can be set in feet. Range: 1 to 30 feet in 1-foot steps.
meters: Distances can be set in meters. Range: 0.3 to 9 meters in 0.3-meter steps.
(TX-SR507)
Front, Center, Surr R, SurrBk R, SurrBk L, Surr L, Subwfr
Specify the distance from the each speaker to your listening position.
(TX-SR577)
Left, FrontH L, Center, FrontH R, Right, Surr R, SurrBk R,
SurrBk L, Surr L, Subwfr
Specify the distance from the each speaker to your listening position.
2-4. Level Cal (Speaker Levels Calibration)
These settings are set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 37).
You can set the volume level of each speaker so that all speakers can be heard equally at the listening position. A pink
noise test tone is output by the front left speaker.
Notes:
• Speakers that you set to “No” or “None” in the “2-2. Sp Config (Speaker Configuration)” (page 66 or 68) do not
output the test tone.
• The speaker levels cannot be adjusted while a pair of headphones is connected or the AV receiver is muted.
(TX-SR507)
Left, Center, Right, Surr R, SurrBk R, SurrBk L, Surr L, Subwfr
The levels can be adjusted from –12 to +12 dB in 1 dB steps (–15 to +12 dB for the subwoofer).
(TX-SR577)
Left, FrontH L, Center, FrontH R, Right, Surr R, SurrBk R,
SurrBk L, Surr L, Subwfr
The levels can be adjusted from –12 to +12 dB in 1 dB steps (–15 to +12 dB for the subwoofer).