Onkyo TX SR507 - Manual (Page 55)

55
UP-A1 series Dock for iPod
With the UP-A1 series Dock (sold separately), you can
easily play the music, photo, or movie stored on your
Apple iPod through the AV receiver and enjoy great
sound. You can use the AV receiver’s remote controller
to operate your iPod.
For information about which iPod models are
supported by the UP-A1 series Dock, see the UP-A1
series Dock’s instruction manual.
Note:
Before using the UP-A1 series Dock, update your iPod
with the latest software, available from the Apple Web
site at: www.apple.com
1. Turn on the AV receiver, and select the [PORT]
selector.
2. Align your iPod with the Dock’s iPod slot, and
carefully place your iPod in the slot, as shown.
■ Adjusting the iPod Adapter
The iPod adapter needs to be adjusted to match your
particular iPod. If there’s a gap between the back of your
iPod and the adapter, turn the adapter counterclockwise
to close the gap. Turning the adapter counterclockwise
moves it forward. Turning it clockwise moves it
backward.
Notes:
• Make sure that the output level of the AV receiver is
set to minimum.
• To prevent iPod connector damage, don’t twist your
iPod when inserting or removing it, and be careful not
to knock over the Dock while your iPod is inserted.
• Do not take off your iPod from the Dock when you
play back the music, photo, or movie stored on your
iPod.
• Don’t use the Dock with any other iPod accessories,
such as FM transmitters and microphones, as they
may cause a malfunction.
• It is recommended that you update your iPod software
before using it with this unit. The updater for the iPod
software is available at the Apple website.
■ Basic Operation
Note:
The AV receiver may take several seconds to startup, so
you might not hear the first few seconds of the first song.
• Auto Power On Function
If you start iPod playback while the AV receiver is
on Standby, the AV receiver will automatically turn
on and select your iPod as the input source. Then,
your iPod will start playback.
• Direct Change Function
If you start iPod playback while listening to another
input source, the AV receiver will automatically
select your iPod as the input source.
• Using the AV receiver's Remote Controller
You can use the AV receiver’s remote controller to
control basic iPod functions.
About the UP-A1 series Dock
For the latest information on the Dock, see the Onkyo
Web site at: www.onkyo.com
Compatible iPod models
Putting Your iPod in the Dock
iPod slot Dock connector
iPod adapter
Remove iPod
case before
inserting
Function Overview
Backward
Forward