Outlaw Audio 990 User Manual

Page 11

Advertising

Outlaw Audio

Owner’s Manual

Model 990 7.1 Channel Preamp/Processor

Owner’s Manual

are often out of sync. Each push of the button increases delay by 1 mil-
lisecond. The on-screen display indicates the amount of delay. After delay
is set, pushing the button again resets delay to 0.

DOLBY MODES (see page 34)

Selects desired Dolby Digital mode, such as Dolby Digital 5.1,
Dolby Digital EX, or Dolby Virtual Surround. The mode selections appear
on the front panel and the on-screen display. Also functions as rewind
button for other devices controlled by the remote.

TUNE MODE (see page 37)

Selects between FM and FM stereo in both main room and Zone 2. The
selected mode appears on-screen.

Source selector buttons (see pages 34, 42)

These buttons select which input is active in the main room. The selected
source appears on the front panel and the on-screen display.

NIGHT button (see page 36)

Activates dynamic range compression to limit peaks for late-night viewing.
Repeated presses select minimum, medium and maximum compression
levels. The compression level is shown on the on-screen display.

14 Status LED Indicator (see page 41)

Indicates when the remote control is in Programming or Learning mode
and flashes to indicate success or failure of these functions.

POWER button (see pages 34, 42)

Turns off the Model 990. Also turns other components controlled by the
remote on and off.

MENU button (see pages 23-33)

Activates the Model 990’s on-screen menu. Also serves as enter button for
numeric keypad when controlling other devices.

STEREO button (see page 35)

Deactivates surround sound and switches to conventional stereo. Stereo
status is indicated on the front panel and the on-screen display.

CHANNEL UP and DOWN buttons (see page 37)

Adjusts AM/FM radio tuning frequency. Frequency appears on both the
front panel and on-screen. Also serves as channel selector when control-
ling other devices.

DIRECT button (see page 37)

This button allows you to directly access a radio station when the tuner is active.
Press it once, then enter the station’s frequency using the numeric keys.

MR button (see page 40)

This button turns the sound and picture on and off in Zone 2 when the
Model 990 is turned off.

TONE button (see page 37)

Activates tone control defeat mode. Press this button once, then toggle
tone control defeat on and off with the cursor up and down buttons. Tone
control status appears on the front panel and on-screen.

DTS MODE button (see page 34)

Selects desired DTS mode, such as DTS 5.1, ES, or Neo:6. The mode selec-
tions appear on the front panel and the on-screen display. Also functions
as rewind button for many other devices controlled by the remote.

Model 990 Remote Control

Remote Controls

��

��

��

��

��

�� 

��

�� 

��

��

�� 

��

�� 

��

�� 

��

��

��

��

��

�

��

PRESET SCAN button

Advances AM/FM tuner to next preset in both main room and Zone 2.
Frequency and band appear on front panel and on-screen.

MEMORY button (see page 37)

Use this button to select a station memory with the internal AM/FM tuner;
press the button then enter the number of the desired memory. Holding this
button down for three seconds activates automatic channel scan, which
scans the band you are on for the next highest active frequency/station.

AM/FM button (see page 37)

Switches to AM/FM tuner. Repeated button pushes switch between AM and
FM bands in main room and second zone.

Advertising

Popular Brands

Popular manuals