Oki C610 - Manual (Page 43)

43 – C610/C711 User’s Guide
PS Setup
(cont.) USB
Protocol
ASCII/RAW Specifies PS communication
protocol mode of data from USB
port.
(In RAW mode, Ctrl-T is invalid).
PS models only.
PCL Setup Font Source Resident Specifies the location of PCL
default font.
Font
Number I0 ~ I90 Sets the PCL font number.
The valid range of this variable
changes depending on the FONT
SOURCE setting at the time. If
the default font is set for FONT
SOURCE, the number starts at 0.
If it is not, the number starts at
1. The maximum value is equal
to the number of fonts installed
in FONT SOURCE.
Font Pitch 0.44 CPI
~
10.00 CPI
~
99.99 CPI Width of the PCL default font in
characters per inch (CPI).
Default font is fixed-pitch,
scalable font.
The value of pitch is displayed
down to the second decimal
place.
Displayed only when the font
selected in Font No. is a fixed-
spacing, scalable font.
Font Height 4.00 point
~
12.00 point
~
999.75 point
Height of the PCL default font.
The value is displayed down to
the second decimal place (in
0.25 point increments).
Displayed only when the font
selected in Font Number is a
proportional-spacing, scalable
font.
Symbol Set PC-8 Sets the symbol set of PCL (see
machine operator panel for
complete list).
ITEM SETTINGS EXPLANATION