Oki C610 - Manual (Page 62)

62 – C610/C711 User’s Guide
Storage Setup
Note:
This menu only displays if the optional SD card is
installed.
ITEM SETTINGS EXPLANATION
Check File
System Execute Resolves mismatch between actual memory
and displayed memory available in a file
system. Performs administration data (FAT
information) recovery. Performs recovery only
for an SD Card.
Check All
Sectors Execute Performs recovery of defective SD Card sector
information and a file system mismatch
mentioned above.
Enable SD
Card No
Yes Even if a machine is inoperable at installation
because of a faulty SD Card, the machine can
be made operable by setting this parameter to
No (ignores the existence of the SD Card).
When No is set, access to a SD Card results in
FAIL because the SD Card is regarded as not
attached.
After setting change and exit from the menu,
the printer will restart.
Erase SD
Card Execute Deletion of all data stored in the SD Card.
DoD 5220.22-M sanitizing formula is used for
clearing the card. The machine will restart
after changing setup. The following message
appears after pressing the Enter button.
Are You Sure? Yes / No
No = return to the source menu.
Yes = the procedure for clearing disk stars
immediately after the machine reboots.
If the Cancel button is held down during
erasing, the following confirmation messages
will appear to discontinue processing.
Do You Wish to Cancel? Yes / No
No= procedure will continue.
Yes = procedure will discontinue.